At present, many rural roads have installed city circuit lights, but many resources will be in danger of being destroyed. So how to make good use of each resource has become the most troublesome thing for people. Facing this embarrassing situation, how to repair the street lamp? The following is the troubleshooting method of the solar street lamp that Xiaobian compiled for you, hoping to help you. Troubleshooting methods for solar street lamps
1. The whole light is off
Ip65 Led Solar Street Light belong to outdoor lighting, and often encounter high temperature or rainy conditions, low temperature or rainy and snowy weather, etc., and the controller of Waterproof Solar Street Light is usually installed inside the light pole, and the rainwater entering is easy to cause short circuit of the controller Phenomenon. First check whether there is water or rust on the wiring part of the controller. If so, it is very likely that the controller has been damaged, and the battery voltage has not been measured. For example, in a 12V Waterproof Solar Street Light Solar power supply system, if the battery voltage is lower than 10.8V, the battery is dead. Does not store power and needs to be replaced. Then check whether there is voltage and current output when the battery board is working normally. If not, the battery board is damaged, replace the battery board. If there is no problem with the above, you should check the light source, only connect the power supply to the light source to see if it is on, if it is not on, replace the light source. 2. The light head flickers
The cause of this failure is poor contact of the line, the battery is out of power, and the storage capacity is seriously reduced. If the line is ok, replace the battery. 3. Short lighting time
The duration of rainy days is short. It is usually caused by the decrease of battery storage capacity and insufficient storage capacity, and it is enough to replace a reasonable battery.
Many solar street lights use dot-matrix LED light sources. In addition to the quality problems of the LED light source itself, some lamp beads will cause this situation due to false welding. The solution is to replace the corresponding lamp beads, weld firmly or replace the entire street lamp head. 5. Battery problems
If the lighting time is short, the battery energy storage decreases, resulting in rainy weather, and the lighting time is short, it is a problem with the battery, and the battery should be replaced. 6. The problem of LED light source
The lamp beads of solar street lamps are not fully bright. In addition to the quality problems of the LED light source itself, there is a welding problem. The lamp beads that fail should be replaced in time or the lamp beads should be welded firmly or the lamp holder should be replaced more directly. The above content is provided by WOSEN. WOSEN is a professional manufacturer and supplier of Led Flood Light, Led Street Light, Led Solar Light, etc. For more information, please visit https://www.wosenled.com/ or contact admin@wosenled.com or WhatsApp +86-13425434349
