How to Turn on Flood Lights with No Wall Switch

Flood lights are powerful outdoor lights that can illuminate large areas of your property, such as your driveway, backyard, or garden. They can also serve as Security Lights, deterring intruders or unwanted animals from entering your premises. However, not all flood lights have a wall switch that you can use to turn them on or off. In this article, we will show you how to turn on flood lights with no wall switch, using different methods and devices.

Method 1: Bypass the Motion Sensor

Some flood lights have a built-in motion sensor that triggers the light whenever it detects movement. This can be convenient, as you don`t have to manually switch on the light every time you need it. However, if you want to have more control over when the light is on, you can bypass the motion sensor and use a wall switch instead. To do this, you will need to:

• Turn off the power supply to the Flood Light at the circuit breaker.
• Open the flood light and remove the power supply board.
• Disconnect the wires from the motion sensor and connect the live wire directly to the power supply input.
• Insulate the unused wires and check for short circuits and continuity.
• Reassemble the flood light and test it.

Method 2: Replace the Flood Light with a Motion Sensor Switch

Another option is to replace the flood light with a motion sensor switch that you can install on the wall. This way, you can turn on the light by waving your hand in front of the switch, or by using a remote control. To do this, you will need to:

• Turn off the power supply to the flood light at the circuit breaker.
• Remove the old fixture and wires.
• Check the installation instructions and adjust the direction of the lights.
• Connect the white and black wires and screw the fixture to the wall.
• Test the power and replace the bulbs if needed.

Method 3: Alter the Settings on the PIR Sensor

PIR stands for passive infrared, which is a type of motion sensor that detects heat and movement. Some flood lights have a PIR sensor that you can adjust to change the sensitivity, time, and lux settings. This can help you customize when and how the light turns on. To do this, you will need to:

• Access the knobs at the back of the PIR sensor.
• Turn the sensitivity knob to increase or decrease the range of detection.
• Turn the time knob to set how long the light stays on after motion is detected.
• Turn the lux knob to set the level of ambient light that triggers the light.

Conclusion

Flood lights are useful for lighting up your outdoor space and enhancing your security. However, if you don`t have a wall switch to control them, you can use one of the methods above to turn them on or off. Whether you want to bypass the motion sensor, replace the flood light with a motion sensor switch, or alter the settings on the PIR sensor, you can find the instructions and videos in this article. We hope you found this article helpful and informative. If you have any questions or feedback, please leave a comment below. Thank you for reading!

If you need to purchase lamps in bulk, please contact us.WOSEN is a professional manufacturer and supplier of Led Flood Light, Led Street Light, Led Solar Light, etc. For more information, please visit https://www.wosenled.com/ or contact admin@wosenled.com or WhatsApp +86-13425434349